EasyGlider PRO ... the logical development – for direct drive brushless motor
The EasyGlider PRO is based on the popular and proven EasyGlider and EasyGlider electric.
The EasyGlider PRO is designed for brushless outrunner motors and LiPo batteries, and a matching power set is available under # 33 2636 or - if you want a little more “oomph” - the upgradepower set # 33 2642.
However, the model can also be built as a pure glider: the kit includes a fuselage nose-cone in which our aero-tow mechanism # 72 3470 can be installed.
The model’s flying characteristics are just right for the beginner, although this by no means implies that the more advanced pilot won’t enjoy it - quite the contrary. If you are an expert you will soon discover that the EasyGlider PRO behaves like a much bigger model, and its performance is also far better than you might expect.
• Low sink rate
• Can be ballasted to expand the airspeed range
• Landing aid - both ailerons raised
• Can be finished using any standard spray-can paints after prior treatment with MULTIprimer # 60 2700
• Pre-fabricated moulded ELAPOR® parts
• Convenient method of aileron servo connection when the wings are fitted
Items Required
-
2 x Nano-S servos
-
2 x Tiny-S servos
-
Reciever
-
Optional Power sets.;
-
Standard - 150w Power Set; Himax 2816-1220 motor, BL27/II Speed control, Folding prop and spinner.
-
Tuning - 250w Power Set; Himax 3516-1130 motor, BL37/II Speed control, Folding prop and spinner
Kit contents
Moulded ELAPOR® parts, GRP spar, all plastic parts required to assemble the model, small items, linkage components, decal sheet, comprehensive, richly illustrated instructions.
Specification
Wingspan 1800 mm
Overall length 1130 mm
All-up weight, glider version approx. 800 g
All-up weight, electric version approx. 900 - 980 g
Total surface area 41.6 dm²
Wing loading 17 g/dm²
Wing loading with ballast, max. 350 g approx. 25 g/dm²
(e.g. for slope-soaring or flying in wind)
RC functions Rudder, elevator, aileron (2 servos),
Landing aid (both ailerons raised)
