'Concorde'
Supersonic
airliner
A
familiar sight to everyone: the unmistakable appearance of Concord in the air.
The
beautiful and aerodynamically efficient delta wing and the two electric motors
in pusher configuration endow the model with an impressive flight performance
over a broad speed range.
Typical
delta landing approaches with low airspeed and high angle of attack are
particularly spectacular. The new type of foam employed for the moulded
components minimizes the risk of breakage if the occasional landing should turn
out less than perfect.
An
important factor at the design stage was the requirement to accommodate low-cost
standard components, and the Concord accepts ordinary batteries and two
standard-size servos.
Concord
is controlled via separate ailerons and elevator, so you don’t even need a
computer system with mixer functions.
The
high level of pre-fabrication and accurately moulded foam parts ensure that
construction is simply and very quick. The large decal sheet supplied as
standard provides an easy way of finishing the model in the colours of Air
France or British Airways.
Kit
contents:
-
Fuselage,
wing and control surfaces moulded in tough foam
-
Fin,
battery cover and motor covers die-cut from lightweight foam
-
Power
400 motors, suppressors and leads
-
Propellers
-
All
linkage components including pushrods, horns etc.
-
Large
coloured decal sheet
- Comprehensive
instructions including tips on test-flying
RC
functions:
-
Aileron
-
Elevator
-
Motor
speed
RC
system:
Min.
3-channel radio control system
Specification
Wingspan: approx. 800 mm
Total surface area: approx.
24 dm2
All-up weight: approx. 1070 g
