RX-6 light M-LINK (Micro) 2.4 GHz receiver # 5 5807
Ultra-compact, ultra-lightweight six-channel receiver exploiting MULTIPLEX 2.4 GHz M-LINK technology: ideal for use in very small and micro-models. The RX-6 light MLINK is fitted with JST connectors, which are in widespread use for indoor models. In
terms of circuit technology it is identical to the RX-5 light M-LINK, and therefore a good, reliable choice for outdoor flying with the smaller model.
The plus-points:
• HOLD / FAIL-SAFE function
• Integral button and LED for:
Binding
FAIL-SAFE programming
RESET
Operating status information
Tip!
Size and weight can be reduced further:
If there are only 4 channels required the outer receiver case can be removed. By cutting off the servo-plug-bench the size and weight will be reduced to approx. 25 x 13 x 7 mm / 1.7 grams.
For technically experienced modellers further modifications are possible to make the rx even smaller and lighter. The receiver.pc-board can be shortened / all the servoplugs disconnected and and servocables soldered directly to the pc-board. A physical size of 21 x 13 x 2.5 mm with just 1.3 grams can be realized. But still all 6 channels can be used.
WARNING: Any modification will invalidate manufacture
Specification:
Servo channel count 6
Reception system 2.4 GHz FHSS (Frequency
Hopping Spread Spectrum)
Operating voltage 3.5 … 9.0 V
Power supply 4 - 5 NiXX cells, 2S LiPo / LiIo
Operating temperature range -20°C … +55°C
Dimensions (L x W x H), excl. aerial approx. 30 x 14 x 8 mm
Weight approx. 3.3 g (1.9 g excl. case)
